The envisionTEC WIC300 is a wax filled photopolymer material
designed for use on the envisionTEC DDP (Digital Dental Printer).
The envisionTEC WIC300 produces highly detailed anatomy with crisp
features. Its stiffness allows for the production and casting of copings
with extremely thin margins as well as full anatomy crowns.
It is also possible to produce a perfectly fitting multiple unit bridge up
to 16 units using the envisionTEC WIC300 material.
The envisionTEC WIC300 has a very low thermal expansion during
burnout and produces a high quality surface finish on the castings. It is the
only photopolymer based material that actually melts during the burnout
cycle allowing for the material to melt out of the investment without
leaving any ash residue which is a common problem associated with the
burning of the photopolymers used in competing technologies.
The low material expansion allows the dental lab to burnout and cast
the material for precious and non-precious alloys in less than One hour
without any metal flashing due to the microcracking in the investment. It
is also possible to burn out the material overnight using a slow burnout
cycle.
The envisionTEC WIC300 is also perfect for producing highly accurate
and detailed full partials for direct investment casting.
